I haven’t watched the video Karl sent. I’m sure it covers it all. But it goes like this: you have one end on which the rubber has a wider entrance. The cable goes there as far up as it will fit. Clamp it down with the screw. The other end captures the cable itself. Clamp it down with the screw. Find the port where the spray lube straw is inserted. Insert it and fill the cable housing to your liking. 

Jim

Sent from my iPhone

> On Dec 30, 2023, at 7:49 PM, Karl <tdiguru@westyventures.com> wrote:
> 
> Youtube.
> 
> https://www.youtube.com/shorts/ywli_ePWA64
> 
>> On 12/30/2023 5:16 PM, Eric Caron wrote:
>> Hey Jim Felder and others,
>> 
>> I just received the motorcycle cable lube tool.
>> 
>> I need some instruction on how to use it.  It came with no directions.
>> 
>> So it is small and basically a square and about a half inch thick and two inches on the sides.
>> 
>> One side has two thumb screws.  On the top? Is a hole with rubber sides.  There is a slot on the “front”  the thumb screws push the sides together in some way.
>> 
>> So, how do I insert the metal cable or the casing part?  Where does the lube get sprayed?
>> 
>> Any tips appreciated.
>> 
>>         I asked my wife to figure it out with me and that did not end successfully.
>> 
>> Eric